Mold Setter

MISSION
Changeover of the productions tools as quickly and safely as possible. Moulds going out must be kept in good conditions for next production, and mould going on should be producing without issues in normal conditions, following injection parameters recorded for that concrete tool.
GENERAL FUNCTIONS

Check production schedule in the beginning of the shift, to know tools changeovers needed, and prepare them in advance, ensuring raw material will be dry and ready on time.

Responsible for the pre-set up area; preheating cooling and / or hot runner of the tool, if it applies, before to fit it into the injection machine, in order to win some time.

Responsible of keeping complete and in good conditions the smed cart.

Verify that parameters of outgoing mould are OK according to the injection parameters sheet for the tool, otherwise report changes and reasons, recording well the new parameters for next production with that tool. Collect last parts OK produced.

Verify that status of ongoing mould is OK for production.

Fit the mould in the machine, connecting pneumatic, hydraulic, electric, cooling; connecting also ejection of the tool and ensuring a right and safe clamping.

Introduce the injection parameters and check if quality of the part is OK, otherwise adjust parameters until getting the OK for production from Quality Engineer, under supervision of the Injection Master and registering all changes done in the official injection parameters.

Responsible of the set up tool book; keeping it always updated and at disposal of production when the tool is working.

Report about any incidence with robot, hands, injection machine, tool or any peripheral.

Guarantee the fulfilment of the Health and Safety policies and procedures in his area of responsibility.

Observe Ficosa’s Code of Ethics to avoid fraudulent practices. Comply with Information Security Management System (ISMS) applicable to the job, along with the training related thereto.

Actively cooperate in maintaining, promoting and improving the OHSE and Quality department.

(*) The duties described are only the most typical of this position and are in no way a comprehensive list.
POSITION REQUIREMENTS

**Academic background**:
Secondary or Vocational Training

**Languages**:
N/A

**Experience**:
3 years in similar position

**Travel**:
N /A

OTHER SPECIFICATIONS

Additional training

Injection, pneumatic, hydraulic, Mechanics, basic electricity, moldflow. Basic machinings in toolshop. Basic training in health and safety, and environmental management

**Languages**:
N/A